Articles on: Connect & set up printers

Bambu Lab integration: supported and recommended hardware

Bambu Lab integration: supported and recommended hardware


Bambu Lab printers connect to SimplyPrint through the SimplyPrint Client, a small app that runs on a device on your network. This guide lists the Bambu Lab printers that work, the devices you can run the Client on, and what the network needs.


In this guide


Supported Bambu Lab printers

Series

Printers

A series

A1, A1 mini, A2L

P series

P1P, P1S, P2S

X series

X1, X1-Carbon, X1E, X2D

H2 series

H2D, H2D Pro, H2S, H2C


Combo versions of these printers work too. Use LAN-only mode with Developer Mode: on Bambu Lab firmware from 2025 on, cloud mode only lets SimplyPrint watch the printer, not start prints or control it.


Devices you can run the Client on

The device must stay on, and awake, whenever you want to use SimplyPrint. If it is off or asleep, SimplyPrint cannot reach your printers. A print that has already started keeps going.


Device

Notes

Raspberry Pi

Pi 3, 4 or 5, or a Pi Zero 2 W, with our ready-to-flash image. 2 GB RAM recommended. A Pi 3 or Zero 2 W has less memory, so it suits a printer or two.

Linux

Any x86_64, aarch64 or armv7l computer, mini PC or server. Installs as a service that starts on boot.

Mac

Intel or Apple Silicon.

Windows

Any modern 64-bit Windows PC. Starts with Windows.

Docker

The official simplyprint/simplyprint-client image, with host networking.

Home Assistant

As an add-on on Home Assistant OS or a Supervised install, 64-bit. New and still experimental.


The Client cannot run on a phone, a tablet or on the printer itself. Once it runs, you can use SimplyPrint from your phone or tablet as usual.


One Client can connect many printers, of several brands.


Our recommendation

A Raspberry Pi 4 or 5 with our image, or a Linux mini PC or server. They are made to run around the clock and use little power.


A Mac or Windows PC works too, as long as it never sleeps, logs out or restarts for updates while you need your printers.


Network requirements

  • Same network. The device running the Client must be on the same local network as your printers.
  • Internet for the Client. The device running the Client needs internet to reach SimplyPrint. In LAN-only mode the printers themselves only need the local network.
  • A stable connection. Use Ethernet or a strong Wi-Fi signal for the Client's device. A weak connection slows down sending files and the camera stream.


Updated on: 27/10/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!