Articles on: Connect & set up printers

Elegoo Centauri Carbon 2 and the Canvas: which model to pick and setting up the Canvas

Elegoo Centauri Carbon 2 and the Canvas: which model to pick and setting up the Canvas


The Elegoo Centauri Carbon 2 connects to SimplyPrint through the SimplyPrint Client. If yours came with the Canvas, the four-spool multi-material unit, SimplyPrint reads the Canvas from the printer for you. This guide covers which model to pick, how to connect it, and what to do when the Canvas does not show up.


In this guide


Which model to pick

When SimplyPrint asks for your printer model, for example in the setup guide or on the compatibility list:


You have

Pick

Centauri Carbon 2 without a Canvas

Centauri Carbon 2

Centauri Carbon 2 that came with a Canvas (the Combo)

Centauri Carbon 2 Combo

The first Centauri Carbon with a Canvas added

Centauri Carbon Canvas


"Centauri Carbon Canvas" is the first Centauri Carbon with the Canvas add-on. It is not a Centauri Carbon 2, even if your Centauri Carbon 2 came with a Canvas.


On the first Centauri Carbon, SimplyPrint does not read the Canvas yet: it doesn't sync the Canvas slots or map your file's filaments to them. The printer itself still works with SimplyPrint. Canvas sync and mapping work on the Centauri Carbon 2 only.


In the SimplyPrint Client, both Centauri Carbon 2 versions are one choice: Elegoo Centauri Carbon 2.


Connect your Centauri Carbon 2

The Centauri Carbon 2 needs its access code. You find it on the printer's LAN Only screen. It is case sensitive.


  1. In the SimplyPrint Client, choose Add printer > Elegoo.
  2. Pick Elegoo Centauri Carbon 2.
  3. Enter the printer's IP address and its access code.
  4. Enter the setup code the Client shows in SimplyPrint.


Check: the printer shows as online in SimplyPrint.


If the Client says it cannot connect, check the access code first. The Centauri Carbon 2 uses a different connection from the first Centauri Carbon, so picking Elegoo Centauri Carbon for a Centauri Carbon 2 does not work either.


How SimplyPrint gets your Canvas

You do not add the Canvas by hand. With the Canvas connected to your Centauri Carbon 2, the SimplyPrint Client reads it from the printer:


  • SimplyPrint shows the Canvas's four slots and the material type and colour in each.
  • When you start a print, SimplyPrint maps the filaments in your file to the Canvas slots.


When the printer reports its multi-material setup, SimplyPrint uses that instead of a setup added by hand.


The Canvas does not show up or is not saved

The refresh button only shows while the printer is online, and only to users with the "Change filament" permission.


  1. Check that the Canvas is connected and shows on the printer's own screen.
  2. Check that the printer was added in the Client as Elegoo Centauri Carbon 2. The Client only reads the Canvas on a Centauri Carbon 2.
  3. Press the refresh button: the circular arrows icon next to the gear icon in the filament section of the printer's page. It asks the printer for the Canvas again.


Check: the four Canvas slots show with the material that is loaded in each.


Updated on: 27/10/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!